There is a locating pin (or deep dimple) in the very center of your leaf springs that keeps the leaves from moving on the axle. The only other way to mis-locate the axle is by destroying the bushings that bolt through the frame.
You can measure your axles for 'square' by using a tape measure. All body dimensions reference from the #2 crossmember (where the motor mounts are welded). Find the center of the crossmember and measure to each side of the rear axle. - Dave
You can measure your axles for 'square' by using a tape measure. All body dimensions reference from the #2 crossmember (where the motor mounts are welded). Find the center of the crossmember and measure to each side of the rear axle. - Dave
Comment