Announcement

Collapse
No announcement yet.

56 Clutch Set

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • KENN
    Experienced
    • Aug 6 2015
    • 108

    56 Clutch Set

    What Is The Disk Size And Pilot Hole Size On A Baby Bird Clutch? is It 11 Inch 10 Spline 1 Inch Pilot Hole? Where Can I Get A Complete Set/ Kit?..thanks Kenn
    WHITE 60 HARDTOP AND 54 FORD SEDAN CUSTOMLINE TBIRD REGISTRY #61860 920-286-2277
  • Wade
    Newbie
    • Sep 4 2013
    • 21

    #2
    You are right with 11 inch 10 spline disc. The Ford parts book shows pilot bearings, a #70-7600-B 1.575"/1.576" O.D.-.6715"/.6725" I.D -
    .495"/.505" thick and a #B-7600-A 1.5743"/1.5748" O.D. = .6689"/.6693" I.D. - .4674"/.4724" thick , for yrs. 49-57 cars and Tbirds.

    Comment

    • KENN
      Experienced
      • Aug 6 2015
      • 108

      #3
      Does It Say Anything About The Size Of Input Shaft? Where The Spline Shaft Goes Into The Disk? Thanks Kenn
      WHITE 60 HARDTOP AND 54 FORD SEDAN CUSTOMLINE TBIRD REGISTRY #61860 920-286-2277

      Comment

      • Wade
        Newbie
        • Sep 4 2013
        • 21

        #4
        No, I looked up the input shaft and it did not give that dimension. I want to say that it is 1 inch but there are too many cobwebs in my head to swear to it. I do have a transmission in my garage, I will go out and measure it in awhile if I can find my calipers (cobwebs again).

        Comment

        • Wade
          Newbie
          • Sep 4 2013
          • 21

          #5
          It is 1 inch .

          Comment

          • KENN
            Experienced
            • Aug 6 2015
            • 108

            #6
            Thanks Wade For Your Help. So Far All Im Finding Is 1 1/8 Inch. Do You Know A Supplier For The Plate, Disk And Bearing? Kenn
            WHITE 60 HARDTOP AND 54 FORD SEDAN CUSTOMLINE TBIRD REGISTRY #61860 920-286-2277

            Comment

            • Wade
              Newbie
              • Sep 4 2013
              • 21

              #7
              I measured 1 inch for the input shaft itself I don't have a clutch disc to measure the actual hole. I checked CASCO Thunderbird parts catalog and they show that they carry the disc, pressure plate, pilot and throw out bearing. They sell only 55-57 Tbird parts so what they have should fit. There are quite a few Tbird parts suppliers out there I would guess that most of them have the clutch parts you need.

              Comment

              Working...
              😀
              🥰
              🤢
              😎
              😡
              👍
              👎