Hi all. I've got a 1962 TBird and the PO went a little crazy with cutting in the trunk:
I can buy the side panels and extensions, and just metal fab pretty much the rest. The problem is I don't know where the seam would be located for the side extensions. This makes it very difficult to get things like the rear quarters (which also need to be replaced) lined up properly. If some one could lift their trunk mat and measure the width of the center panel, like so:
It would be greatly appreciated. With that measurement I can make the center panel the proper width and then start building back out from there.
It would also be great if you could measure in three spots so that any taper would be evident. I'm hoping it's just a square section. Would make repairing it much easier.
Cheers.
I can buy the side panels and extensions, and just metal fab pretty much the rest. The problem is I don't know where the seam would be located for the side extensions. This makes it very difficult to get things like the rear quarters (which also need to be replaced) lined up properly. If some one could lift their trunk mat and measure the width of the center panel, like so:
It would be greatly appreciated. With that measurement I can make the center panel the proper width and then start building back out from there.
It would also be great if you could measure in three spots so that any taper would be evident. I'm hoping it's just a square section. Would make repairing it much easier.
Cheers.
Comment