Intalled the 3G on the Bird, using the stock Generator bracket. It took a little welding, but if you have access, its pretty simple.
I removed the pulley from the old generator and put it in the lathe, and cut the fan blades off. The 3g has it's own internal fan. My future plan is to use an oversized pulley, but this works for now. And you don't necessarily have to cut the blades off.
I elongated the hole that bolts the bracket to the side of the block by 3/4" back towards the rear of the car. This allows you to push the set up forward to align pulleys.
Then I took the top bracket that comes from the water pump, to the generator bracket, (upright vertical piece) and took the bend out. With it being straight it pushes the bracket out 1/4". Again you don't necessarily need to do this, but you will need another spacer.
Back to the lathe, I machined one spacer at
-2 1/2" to fit between the alternator and the rear dog ear of the bracket that bolts to the block.
2 x 1/8" washers go in between the water pump and vertical bracket.
I then cut out a piece of 3/16 steel, "half round"
Welded at the corner where the bottom and vertical bracket meets, for my adjuster. It wraps half way around the alternator (much like C.R.A.P's adjuster bracket) Milled in a slotted hole for adjustment, and viola. 3G in 1960 Thunderbird. So far the pulley lines up perfect. The cool thing is, it's adjustable back and forth to perfectly align the pulleys. I have room for adjustment in both directions. With everything locked down and tight, it runs smooth. I'm sure other cars will be a bit different in spacing, but after you elongate the hole for the block mount, you can pull measurements.
I hope someone can use this too. The best thing about using the old bracket is, i can slide it back, and still mount a generator if ever the desire too. Thanks, Audie Draper.
I removed the pulley from the old generator and put it in the lathe, and cut the fan blades off. The 3g has it's own internal fan. My future plan is to use an oversized pulley, but this works for now. And you don't necessarily have to cut the blades off.
I elongated the hole that bolts the bracket to the side of the block by 3/4" back towards the rear of the car. This allows you to push the set up forward to align pulleys.
Then I took the top bracket that comes from the water pump, to the generator bracket, (upright vertical piece) and took the bend out. With it being straight it pushes the bracket out 1/4". Again you don't necessarily need to do this, but you will need another spacer.
Back to the lathe, I machined one spacer at
-2 1/2" to fit between the alternator and the rear dog ear of the bracket that bolts to the block.
2 x 1/8" washers go in between the water pump and vertical bracket.
I then cut out a piece of 3/16 steel, "half round"
Welded at the corner where the bottom and vertical bracket meets, for my adjuster. It wraps half way around the alternator (much like C.R.A.P's adjuster bracket) Milled in a slotted hole for adjustment, and viola. 3G in 1960 Thunderbird. So far the pulley lines up perfect. The cool thing is, it's adjustable back and forth to perfectly align the pulleys. I have room for adjustment in both directions. With everything locked down and tight, it runs smooth. I'm sure other cars will be a bit different in spacing, but after you elongate the hole for the block mount, you can pull measurements.
I hope someone can use this too. The best thing about using the old bracket is, i can slide it back, and still mount a generator if ever the desire too. Thanks, Audie Draper.
Comment