Hello everyone, got the oil pumping again, oil drive shaft was floating.
Now time to set valve lash.
Can someone tell me the procedure for adjusting the lash on a hydrualic lifter with non adjustable rockers.
I started the car for a couple of min. but it ran very bad and fell dead, I am assuming it is bad or incorrect valve lash.
Timing is good and I have a rebuilt holly 750 on it.
I have read you have to set preload and then the lash.
I read the instructions online for the 58, but I beleive it is for adjustable rockers.
Thanks,
Barry
Now time to set valve lash.
Can someone tell me the procedure for adjusting the lash on a hydrualic lifter with non adjustable rockers.
I started the car for a couple of min. but it ran very bad and fell dead, I am assuming it is bad or incorrect valve lash.
Timing is good and I have a rebuilt holly 750 on it.
I have read you have to set preload and then the lash.
I read the instructions online for the 58, but I beleive it is for adjustable rockers.
Thanks,
Barry
Comment