More on my 430 "refresh" --- After taking off the distributor, I see that one of the many places the valley cover was leaking is around the stud for the distibutor hold-down clamp. Should there be some sort of grommet or seal there? I found nothing in the engine gasket set that looked promising. The parts books and shop manual were not helpful either.
Anyone with a 430 shed some light on this?
See link for pic:
John
430 Tbird HT
registry #1590
Anyone with a 430 shed some light on this?
See link for pic:
John
430 Tbird HT
registry #1590
Comment