I'm going to be getting my motor rebuilt soon and will need to have a working temp and oil pressure gauge when I'm done.
Up until this point I really didn't care because I knew I would be getting the 390 rebuilt. I don't care if the gauges are factory, maybe even just a set of gauges I can bolt to the dash - this is the rusty Rat rod type build I'm doing in case you're not familiar with my car.
It has a 390 that will be getting a 428 crank, edelbrock RPM Performer intake and carb, headers, etc. Does anyone know of the easiest, fairly cheap way to add a temp sensor and oil pressure gauge to this setup?
thx in advance, Dave J
Up until this point I really didn't care because I knew I would be getting the 390 rebuilt. I don't care if the gauges are factory, maybe even just a set of gauges I can bolt to the dash - this is the rusty Rat rod type build I'm doing in case you're not familiar with my car.
It has a 390 that will be getting a 428 crank, edelbrock RPM Performer intake and carb, headers, etc. Does anyone know of the easiest, fairly cheap way to add a temp sensor and oil pressure gauge to this setup?
thx in advance, Dave J
Comment